Chat
|
Daily Search
|
My GenForum
|
Community Standards
|
Terms of Service
|
|
|
I'm hoping a previous UFT user can help me with this problem...sometimes I get a Program Error message that states: NESTING TOO DEEP, RETRY, OR CANCEL. If I remember correcting either choice causes the program to go crazy, and I cannot get out of it without shutting down my computer. Oftentimes, it reappears again, and again. Other times, not at all. Any ideas welcome as I can't figure out where the problem lies...thanks for any and all suggestions.
I'm seriously thinking of updating to TMG when the new version is available, but worry this problem may come with my data. I've played around with the current TMG program, but since I can't actually insert any data, I'm not sure I would like it as well...UFT isn't all the bad, is it?
Notify Administrator about this message?
Followups:
|
| http://genforum.genealogy.com/tmg/messages/4292.html | ||
 |
Link to GenForum Add Forum |
|